Superwave Laser Technology Co.,Ltd
Call us:+86-139 2523 7065
E-mail:info@superwavelaser.com
Products
[[TD-Hot Products]]
Exhibition
Home > Exhibition > Content

Safety precautions in the operation of CO2 laser marking machine

Superwave Laser Technology Co.,Ltd | Updated: Mar 26, 2018



Laser marking machine with laser wavelength of 10.64um is harmful to human skin at work, so the operator should pay attention to safety in the process. Laser marking machine at work, if it is dangerous to malfunction, novice must pass through professional training to independent operation, according to our experience summed up the laser cutting machine safety work 13 details, hope to help friends are using laser equipment, operational details are as follows:


1. Comply with general laser equipment safety procedures. Start the laser in strict accordance with the laser start-up procedure.

2. The operator must be trained to be familiar with the equipment structure, performance and knowledge of operating system.

3. Wear protective equipment according to the regulations, and wear protective glasses near the laser beam.

4. Do not process a material before it can be irradiated or heated to avoid the potential hazard of smoke and steam.

5. The operator shall not leave the position or the person to be treated without authorization while the equipment is in operation. If it is necessary to leave, the operator should stop or disconnect the power switch.

6. Keep the fire extinguisher handy and handy; Turn off the laser or light brake when not working; Do not place paper, cloth or other combustible materials near unprotected laser beams.

7. When abnormity is found in the process of processing, it should stop immediately, troubleshoot or report to the supervisor.

8. Keep the laser, bed and surrounding area clean, orderly and free of oil, and the workpiece, sheet and waste materials should be piled up according to regulations.

9. When using cylinders, avoid welding wires to avoid leakage accidents. The use and transportation of gas cylinders shall comply with the monitoring procedures of gas cylinders. Do not expose cylinders in the sun or near heat sources. The operator must stand on the side of the bottle when opening the bottle valve.

10. Comply with the high - voltage safety regulations during maintenance. Every 40 hours or weekly maintenance, 1, 000 hours per operation, or every 6 months maintenance shall be conducted according to the regulations and procedures.

11. After starting the machine, manually operate the machine at low speed X and Y direction, and check for abnormal conditions.

12. After entering the new workpiece program, test run and check its operation.

13. When working, pay attention to the operation of the machine tool, so as to avoid the cutting machine out of the range of effective travel or two colliding accidents.


   Superwave Portable CO2 Laser Marker


                   CO2 Laser Marking Machine.png