Superwave Laser Technology Co.,Ltd
Call us:+86-139 2523 7065
E-mail:info@superwavelaser.com
Products
[[TD-Hot Products]]
Exhibition
Home > Exhibition > Content

Light path adjustment for laser equipment-superwave laser machine-fiber laser

Superwave Laser Technology Co.,Ltd | Updated: Dec 19, 2017


1. Ensure that the beam from the laser tube is fired at the center of the 1 # mirror.

2, in front of the 2 # reflector with double-sided tape, remove the beam to the most close to the location of the laser tube, according to some appropriate light intensity (control), playing on a tag (special note: to prevent laser radiation injury, please first with a piece of cardboard to test out the approximate location of a light spot, then adjust).

3. Gradually move the beam to the farthest position from the laser tube and click on a marker.

4. If the two markers do not overlap, adjust the 1 # reflector to align the two marking centers.

5. Repeat step 2 to step 4 until the two mark centers overlap completely.

6. Put double-sided adhesive paper in front of the 3 # mirror, move the car (laser head) to the nearest 2 # reflector position, press the point (control the proper light intensity), and make a mark.

7, gradually remove the laser (car) to the location of the farthest from the 2 # mirror, according to some, it's best to start with a piece of cardboard, first measure the approximate location of a spot, in case of injury), playing on a tag.

8. If the two markers do not overlap, adjust the 2 # reflector to align the two marking centers.

Repeat steps 6 to 8, until the two mark centers overlap completely.

10. Put double-sided glue on the hole in front of the 3 # reflector, and click to mark. If at the center, qualified.  

11. If the laser does not fall into the center of the optical hole